Felix printers Felix 2.0 Instruction Manual page 12

Start to align the z-axis guide. Push the bottom side against the
printed part. Measure the distance of the edge as indicated above. The
distance should be 12mm.
Mount the z_axis_carrier_pt2_v11_F2_0 onto the cart with two
M5x16 bolts. Don't forget to place the m5 washers. Mount a motor
onto the plastic part. IMPORTANT: match the orientation of the wires
according to the picture.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
12mm
www.FELIXprinters.com

Mount the 2 bearings.
Order from right to left.
M4x25 bolt, 2x small bearing, small washer, plastic part, small washer,
M4 self locking nut.
Then insert 2x m4 selflocking nuts besides the just mounted rolls into
the plastic part as shown in the picture above.
Page 12 of 51