Felix printers Felix 2.0 Instruction Manual page 31

Re-orientate the frame by placing the wide beam onto a table. Mount
the y-axis cart on the z-axis part with four M3x16 bolts with the m3
washers.
Mount the y-stage bracket pt4 onto the y-stage bracket pt6 with an
m4x25 bolt.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
www.FELIXprinters.com

Now it is time to put the left over belt from the x-axis onto the y-axis.
Take the belt and cut it off straight.
Push the belt inside the bracket. Let the belt make contact with as
much teeth of the bracket as possible. Also push it as far as possible,
use a small allen key for that. If you have misplaced the belt or you
want to remove it, on top of the bracket is a small hole which can be
used to push out the belt with a small allen key.
Guide the belt over the pulley and 2 bearings as indicated above.
NOTE 1: The pictures are from the Felix 1.0, but the procedure is the
same.
NOTE 2: If you are doing this module before assembling the x-axis
module, do not waste unnecessary pieces of belt, because it is
needed for the X-axis!!
Page 31 of 51