Felix printers Felix 2.0 Instruction Manual page 23

Position and fix the rail onto the frame. Let the rail touch the x-axis belt
mount part.
The distance along the rail and the edge of the beam should be 14mm.
This way it is centered perfectly over the slot of the beam.
Top of plastic part should
touch aluminum beam.
Mount the x-axis motor bracket onto the frame with an M4x16 bolt,
use a small washer underneath the bolt-head.
IMPORTANT: The top of the plastic part should touch the top
aluminum beam as indicated in green above.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
14mm
www.FELIXprinters.com

Mount the extruder assembly onto the cart of the linear guide, with 4
m3x6 countersunk bolts.
Guide the belt through the extruder carriage.
Belt guiding
channel
Page 23 of 51