Felix printers Felix 2.0 Instruction Manual page 11

t_slot nut - 8 ST M4
Put three in the frame as indicated in the picture
above.
Put some tape on the far edge of the rail to prevent the cart from
sliding off.
M4x20 bolt + small
washer
Make sure part touches frame
First mount the linear guide loosely onto the frame with M4x20 bolts.
z-axis-motor-bracket_v10_F2
Then mount the
indicated above with m4x20 bolts and important use small washers.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
onto the frame,
www.FELIXprinters.com

Put the motor in place and guide the wires through the hole
Motor wires
Before mounting the motor make sure the wires are orientated as
above
Mount a motor with the m3x8 CSK (countersunk head) bolts.
Page 11 of 51