Module 1: Frame (Time: 10-30 Minutes) - Felix printers Felix 2.0 Instruction Manual

6

MODULE 1: FRAME (TIME: 10-30 MINUTES)

Required for this module
Tools
- Allen key set
- Level reference surface
- Level
Parts
- Bag with description 'frame module'.
- Aluminum beams.
The goal of this module is to create the frame on the right. Try to make everything as perpendicular as possible to each other. Let surfaces align as
good as possible. A good idea is to use a level tool.
BOM for frame module
Part
40x40x400 profile, incl 2xM8
40x40x400 profile, incl 1xM8, 1xD7
40x40x400 profile, incl 3xD7
80x40x440 incl work
40x40 protective caps
80x40 protective caps
frame connector set
handle incl protective cap
hex sockethead bolt M6x1(or M8, depends on the used
handle type)
t-slot nut - 8 ST M6 (or M8, depends on the used handle
type)
t-slot nut - 8 ST M4
dampning feet
strip for putting away cable pieces of 40 cm
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
Amount
1
2
1
1
4
1
6
1
2
2
15
6
2
www.FELIXprinters.com

2 3 4
1
Collect the parts shown above. Notice the holes in the beams.
To make it understandable, the beams are described as follows:
Beam 1: 40x40x400mm beam, has 3 drilled holes
Beam 2: 40x40x400mm beam, has 1 drilled hole and one thread at
the far end of the beam
Beam 3: 40x40x400mm beam, has 2 threads at the far ends.
Beam 4: 80x40x440mm beam has one drilled hole and one thread
at the bottom.
Some of the beams have a screw thread on the far ends of the beam.
These are present for the frame connectors.
Overview of frame
module
Page 6 of 51