Felix printers Felix 2.0 Instruction Manual page 38

Guide the cables of the z-axis table like indicated above. Make sure the
wires are mounted to the small aluminum beam as indicated above.
This provides tension relieve to the wires.
Make a loop as indicated above. Make sure that when moving the
table from one side to the loop is just long enough. Make use of cable
ties to better form the loop. They can easily be removed later on.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
www.FELIXprinters.com

Guide the cables of the foil-heater along as shown above. Wrap a
cable-tie around it to again provide tension relieve on the cable.
Cut off a piece of 14 cm of frame strip.
Make a second loop and guide it as shown above. This loop is
necessary to let the table move up and down. Again make use of the
cable ties to form the loop.
Page 38 of 51