Felix printers Felix 2.0 Instruction Manual page 30

Now place the y-axis onto the table. When it doesn't directly fit, there is
no need to file any parts. The three bolts can be slightly re-oriented.
This can be done to exert a little sideway force on the bolt. When it still
doesn't fit, you could try to adjust the position of the small aluminum
beam.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
www.FELIXprinters.com

After placement mount table bolts with an M4 thin nut. Use a small
washer underneath the m4 nuts at the plastic parts. Use a large washer
for the bolt at the small aluminum beam.
Page 30 of 51