Module 2: Z-Axis (Time: 45-90 Min.) - Felix printers Felix 2.0 Instruction Manual

7

MODULE 2: Z-AXIS (TIME: 45-90 MIN.)

Note: Most holes are designed to minimize the need for any post processing, like filing and drilling. Sometimes, however the bolts will not fit
smoothly and it therefore needs to be drilled out slightly. Required drill sizes can be 3, 4 and 5mm.
BOM Z-axis
Part description
Hiwin lineair ball bearing set -
HGW15CC1R300Z0
Trapezium spindle + bronze nut
motor nema 17
z-spindelmount bottom - v2
pulley_motor_HTD
z-axis-motor-bracket_v10_F2
z_axis_carrier_pt1_v15_F2_0
z_axis_carrier_pt2_v11_F2_0
optosensor
small bearing
z-axis-limitswitch_vane_v6_F2_0
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
Amount
1
1
2
1
1
1
1
1
2
4
1
www.FELIXprinters.com

Get the parts indicated in the list above.
IMPORTANT: DO NOT let the cart
of the linear bearing go off the rail.
There are small balls in there which
might fall out when the cart rolls of
the rail.
Place the frame on a table let the back face of the wide beam rest on
the table surface.
Page 10 of 51