Table of Contents
Advertisement
40m
m
Mount the powersupply assembly onto the frame with m4x16 bolts
including washers.
Before mounting the electronics make sure the potmeters are set ok.
The pot-meters shown in the figure above regulate the power to the
motors.
full-power
The pot meters have a turning range. Fully counter clockwise is full
power to the stepper drivers. Fully clockwise is no-power to the
stepper drivers.
Be carefull with turning the potmeter to full power. Over time the
stepper drivers may become too hot. There is a self protection
mechanism in the chip which will temporarily turn the chip off to cool
itself down. It will protect itself, but this is off course unwanted
behavior as it will give intermittent movement during printing. Do the
following as a starting point. If this occurs, then lower the power.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
no-power
www.FELIXprinters.com
Slide the electronics box in like displayed above.
Page 36 of 51
Hide quick links:
Advertisement
Table of Contents
