Felix printers Felix 2.0 Instruction Manual page 13

On the bottom insert the bronze nut into the plastic part.
z_axis_carrier_pt1_v15_F2_0
Take the
the picture above onto the already mounted plastic part.
support@FELIXprinters.com
Assembly instruction manual FELIX 2.0 3d printer
part and slide it as indicated on
www.FELIXprinters.com

As indicated screw on both sides m4x20 bolts into the part to clamp
the 2 big plastic parts together.
Mount the big part onto the cart of the linear bearing with M5x16
bolts, don't forget the M5 washers!
Put a piece of the supplied double side tape underneath 2 opto-
sensors
Page 13 of 51