Felix printers Felix 2.0 Instruction Manual page 18

Assembly instruction manual FELIX 2.0 3d printer
Insert the m4 self locking nuts into the hexagon holes of the
extru_base_pt4, use an m4x20 bolt including washer as indicated
above. Make sure the wires match and also the orientation of the sticker
on the fan. The fan blows out air at the side of the sticker.
Take the extru_base_pt2 and drill out the hole with a 4mm drill as
shown above.
Mount the motor onto the extru_base_pt2 part displayed above and
match the orientation of the wires.
support@FELIXprinters.com www.FELIXprinters.com Page 18 of 51
