Installing the drive
First or "master" hard disk drive (HDD)
Slot for a second HDD
Slot for a removable-media drive
Rear drive bay for two SCSI hard disk drives
8 / 2
R e m o v a b l e M e d i a D r i v e U p g r a d e s
To install a removable-media drive:
Turn off the computer and unplug all power
If there is a diskette in the diskette drive, remove
Take suitable anti-static precautions and remove
all the system panels. For more information see
"Anti-static precautions" in the Safety &
Regulatory Notices at the start of this manual.
Carefully remove the plastic bezel blanking
insert from the selected drive slot by pushing it
out from the rear with a blunt instrument (for
example, the end of a rubber-tipped pencil). A
hole for this is provided inside the system unit,
alongside the drive bay.
Pull out the metal blanking plate from the front
of the internal drive bay metalwork.
Carefully slide the new drive into the bay from
the front and secure it on both sides using the
special screws provided with the drive.