Attach a spare power cable to the drive (it does
not matter greatly which of the available power
cables you choose).
8a. If you are fitting a SCSI device, install the SCSI
host bus adapter card as described in the
Expansion Cards chapter of this manual, then
connect the ribbon cable supplied with the
device (or the card) between the rear of the
device and the card.
8b. If you are fitting a second ATA device, attach
the spare connector on the CD-ROM ribbon
(signal) cable to the new drive.
Attach any other signal cables as instructed in
10. Check to ensure that no other cables or
connections have become dislodged or trapped
during the work, then the system unit panels.
Finally, follow any further instructions supplied with
the drive (for example, for installing software relating
to the drive).
R e m o v a b l e M e d i a D r i v e U p g r a d e s
8 / 3