Table of Contents
Advertisement
OWNER'S HANDBOOK
Adding more video memory
Video memory is memory reserved for use by the on-
board video controller. More video memory can
provide more colours or higher resolutions to an
extent determined by the capabilities of your monitor.
If your computer has 2 Mbyte of video memory, you
can upgrade it to the maximum of 4 Mbytes by
adding a SODIMM (Small Outline DIMM) module.
1.
Turn off the computer and unplug all power
cords.
2.
Take suitable anti-static precautions and remove
the right side panel. For more information see
the "Anti-static precautions" section in the Safety
& Regulatory Notices at the start of this manual.
3.
Remove any expansion cards that impede access
to the video memory upgrade socket (see the
diagram at the start of this chapter).
4.
Unpack the upgrade kit. Hold the SODIMM
chip by its edges and be careful not to touch the
metal pins.
5 / 1 0
M o t h e r b o a r d F e a t u r e s & U p g r a d e s : P e n t i u m s y s t e m s
5.
Insert the SODIMM into the socket as shown
below.
6.
Replace any expansion cards you removed earlier
and refit the right side panel.
If the computer does not automatically detect the new
memory the first time you turn it on, start the BIOS
Setup utility, go to the Advanced menu and change
the Reset Configuration Data item to "Yes", then
restart the computer.
You can then reconfigure your operating system to
use the expanded capabilities of the video controller.
Advertisement
Table of Contents
