Download  Print this page

Adding More Memory - Mitsubishi Electric MS Series Owner's Handbook Manual

Hide thumbs


Adding more memory

You can give your PC more memory by adding or
replacing memory modules called "DIMMs".
The motherboard's three DIMM sockets accept
DIMMs of up to 128 Mbytes in any combination
(giving a maximum memory capacity of 384 Mbytes).
The slot nearest to the processor is recommended to
be used first.
This is a DIMM (Dual In-line Memory Module).
M o t h e r b o a r d F e a t u r e s & U p g r a d e s : P e n t i u m I I s y s t e m s
Technical note
The DIMMs you use must have the following
specification: gold contacts, 3.3V, 64 or 72-bit,
unbuffered, SDRAM-type with Serial Presence Detect
(SPD) and a CAS latency of 2 at 66 MHz. If you use
any other type of DIMM you risk damaging the
The ECC capabilities of 72-bit DIMMs will only
operate if all the DIMMs in the system are 72-bit.
Before you begin
Turn off the computer and unplug all power
Take suitable anti-static precautions and remove
the right side panel. For more information see
the section on "Anti-static precautions" in the
Safety & Regulatory Notices at the start of this
Remove any expansion cards that impede access
to the DIMM sockets.
6 / 9


Table of Contents

This manual is also suitable for:

Apricot ms series