Installing A Hard Drive In The Carrier; Installing A Hard Drive Behind The Power Supply - Mitsubishi Electric Apricot LS700 Owner's Handbook Manual

C h a s s i s a n d c o m p o n e n t s
Removing a Hard Drive from the Diskette Drive Carrier

Installing a Hard Drive Behind the Power Supply.

2/16 LS700 HANDBOOK
Figure 14. Installing a Hard Drive in the Carrier
1. Observe the precautions in 'Before You Begin'.
2. Remove the floppy diskette drive carrier.
3. Remove the three screws holding the drive to the
carrier.
4. Slide the drive out of the carrier and place it on an
antistatic surface.
5. Install the drive carrier back into the chassis.
W W A A R R N N I I N N G G
This procedure should be done only by qualified technical
personnel. Unplug the computer before doing the procedures
described here.
A