Refit the heatsink support, making sure that it is
correctly and fully seated on the pins. It should
snap into place.
This bracket may not be fitted with some
heatsink designs, or may not be needed
with the the new processor.
The upgrade or Overdrive processor may have
its own cooling fan built into the heatsink. This
will have a power lead that will need to be
connected to PL3 on the motherboard, (marked
'16' on the motherboard diagram).
Now adjust the processor multiplier speed links
on the motherboard, (Jumpers 5 to 8) in
conjunction with the new processor's data sheet.
This processor requires continuous airflow. Ensure that
the supply lead for the front casing fan is still connected to
PL2 to ensure adequate airflow over the processor
When you have finished, replace any expansion cards
you needed to remove, then refit the right side panel.
M o t h e r b o a r d F e a t u r e s & U p g r a d e s : P e n t i u m I I s y s t e m s
6 / 1 5