Variable Loading Floor In Boot - Skoda Yeti Owner's Manual

›
Hang the carabines at the ends of the strap into the lashing eyes behind the
C
rear seats.
›
Pull the belts through the tensioning clasp.
Removing the net partition
›
Undo the belts on both sides and unhook the carabines
›
Push the cross rod first of all on the one side and then on the other side to-
wards the rear.
›
Remove the cross rod from the mounts
Packing the net partition
›
Press the red button of the joint
›
Put the separation net folded together in the bag and close it.
›
Attach the bag with the aid of the plastic carabines to the eyes on the left and
right boot trim panel.
Installing and removing the net partition behind the rear seats is carried out anal-
ogously as behind the rear seats. Use the lower fixing eyes on the carrier rails in
order to attach the carabines. To enlarge the boot, the rear seats can be removed.
Installing and removing the net partition behind the rear seats with variable load-
ing floor » page 70 is carried out analogously as behind the rear seats without
variable loading floor. Use the lower fixing eyes on the carrier rails in order to at-
tach the carabines.
The opening » Fig. 61 in the net partition is designed to feed through the
D
three-point seat belt » page 165.

Variable loading floor in boot


Introduction
This chapter contains information on the following subjects:
Removing the variable loading floor
Removing and installing carrier rails
The variable loading floor makes it easier to handle bulky goods and creates an
even boot floor when the rear seat backrests are folded forward.
CAUTION
The maximum permissible load of the variable loading floor is 75 kg.
70
Using the system
» Fig. 61.
C
.
B
A » Fig. 61- the joint becomes loose.
Note
The room under the variable loading floor can be used to stow objects.
■
If the variable loading floor is installed, no flexible storage compartment can be
■
installed.
Removing the variable loading floor
Fig. 62 Boot: Folding up/removing the variable loading floor

First read and observe the introductory information and safety warn-
ings on page 70.

Remove variable loading floor
›
Fold up the loading floor by moving it in the direction of the arrow
›
Fold up the variable loading floor in direction of arrow
›
Pull on both sides of the locking levers in direction of arrow
›
Remove the variable loading floor in direction of arrow
›
The variable loading floor is installed in the reverse order.
Secure the variable loading floor in the raised position
›
Fold up the hooks on the fastening strip in direction of arrow
70
page 68.
›
71
Fold up the variable loading floor behind the rear back backrests.
›
Fold down the hooks in direction of arrow
›
Support the variable loading floor on the hooks folded downwards.
» Fig. 62.
1
.
2
.
3
.
4
» Fig. 58 on
1
as far as the stop.
3

