Bulbs
Introduction
This chapter contains information on the following subjects:
Headlights
High and low beams
Foglights and daytime running lights
Replacing the bulb for the licence plate light
Tail light
Some manual skills are required to change a bulb. For this reason, we recommend
having bulbs replaced by a specialist garage or seeking other expert help in the
event of any uncertainties.
›
Switch off the ignition and all of the lights before replacing a bulb.
›
Faulty bulbs must only be replaced with the same type of bulbs. The designa-
tion is located on the light socket or the glass bulb.
›
A stowage compartment for replacement bulbs is located in a plastic box in the
spare wheel or underneath the floor covering in the boot.
WARNING
Accidents can be caused if the road in front of the vehicle is not sufficiently
■
illuminated and the vehicle cannot or can only be seen with difficulty by other
road users.
Always read and observe the warnings before completing any work in the
■
engine compartment
» page
192, Engine compartment.
Bulbs H7 and H4 are pressurised and may burst when changed - there is a
■
risk of injury. We therefore recommended wearing gloves and safety glasses
when changing a bulb.
Gas discharge bulbs (xenon bulbs) operate with a high voltage, professional
■
knowledge is required – risk of death!
CAUTION
Do not take hold of the glass bulb with naked fingers (even the smallest
■
amount of dirt reduces the working life of the light bulb). Use a clean cloth, nap-
kin, or similar.
When removing and installing the number plate light and tail light make sure
■
that the paintwork of the vehicle and the tail light are not damaged.
228
Do-it-yourself
Note
This Owner's Manual only describes the replacement of bulbs where it is possi-
■
ble to replace the bulbs on your own without any complications arising. Other
bulbs must be replaced by a specialist garage.
We recommend that a box of replacement bulbs always be carried in the vehi-
■
cle. Replacement bulbs can be purchased from ŠKODAOriginal Accessories.
229
In order to facilitate the removal of the fixture with the bulb for the tail light
■
229
(halogen headlight), we recommend to remove first of all the connector of the
230
bulb for the low beam light.
230
We recommend having the headlight settings checked by a specialist garage af-
■
231
ter replacing a bulb in the main or low beam.
Gas discharge bulbs and LED diodes are replaced by a specialist garage.
■