Voice Control - Skoda Yeti Owner's Manual

Dialogue

First read and observe the introductory information given on page 109.
The period of time during which the system is ready to receive voice commands
and to carry them out is called a dialogue. The system gives audible feedback and
guides you if necessary through the relevant functions.
Optimum understanding of the voice commands depends on several factors.
›
Speak with a normal tone of voice without intonation and excessive pauses.
›
Avoid a bad pronunciation.
›
Close the doors, windows and sliding roof, to reduce or stop disturbing exterior
noise.
›
It is recommended to speak louder at higher speeds, so that the tone of your
voice is louder than the increased surrounding noise.
›
During the dialogue, limit additional noise in the vehicle, e.g. passengers talking
at the same time.
›
Do not speak, if the system makes an announcement.
The microphone for voice control is inserted in the moulded headliner and direc-
ted to the driver and front passenger. Therefore the driver and the front passen-
ger can operate the equipment.
Entering a phone number
The telephone number can be entered as a continuous series of individually spo-
ken digits (the whole number at once) or in the form of digital blocks (separated
by short pauses). After each order of digits (separation through brief voice pause)
all of the digits detected up to now are repeated by the system.
The digits 0 - 9, symbols +, , # are permitted. The system detects no continuous
digit combinations such as twenty-three, but only individually spoken digits (two,
three).
Activating voice control - GSM II
›
by briefly pressing the button
1
steering wheel,
›
by briefly pressing the button

1)
Not valid for vehicles with the Columbus navigation system.
110
Using the system
» Fig. 95 on page 99 on the multifunction
on the adapter » Fig. 97 on page 103.
1)
Deactivating voice control - GSM II
If the system is currently playing a message, the message that is currently being
played will have to be stopped:
›
by briefly pressing the button

›
by briefly pressing the button
1
If the system expects a voice command, you can end the dialogue yourself:
›
with the CANCEL voice command;
›
by pressing the button on the adapter

›
by briefly pressing the button
1
Activating voice control - GSM III
The dialogue can be started at any time by pressing the button
page 99 on the multifunction steering wheel
Deactivating voice control - GSM III
If the system is currently playing a message, the message that is currently being
played must be terminated by pressing the button
multi-function steering wheel.
If the system expects a voice command, you can end the dialogue yourself:
›
with the CANCEL voice command;
›
by briefly pressing the button
1
steering wheel.
Note
The dialogue of an incoming call is immediately interrupted.
■
The voice control is only possible in vehicles fitted with a multifunction steering
■
wheel with telephone control or a phone mount and adapter.
On vehicles that are factory-fitted with the Columbus navigation system, it is
■
only possible to operate the voice control for the telephone via this
ating instructions for the Columbus navigation system, chapter Voice control for
the navigation system.
on the adapter » Fig. 97 on page 103;
1)
on the multifunction steering wheel.
» Fig. 97 on page 103;
1)
on the multifunction steering wheel.
» Fig. 95
1
.
1)
» Fig. 95 on page 99 on the
1
» Fig. 95 on page 99 on the multifunction
device»
on
Oper-
