During the connecting procedure, no other mobile phone may be connected with
the hands-free system.
Up to four mobile phones can be paired with the hands-free system, whereby on-
ly one mobile phone can communicate with the hands-free system.
The visibility of the hands-free system is automatically switched off 3 minutes af-
ter the ignition is switched on and is also deactivated when the mobile phone has
connected to the hands-free system.
Restoring the visibility of the hands-free system
If you have not managed to connect your mobile phone with the hands-free sys-
tem within 3 minutes of switching on the ignition, the visibility of the hands-free
system can be reestablished for 3 minutes in the following ways.
›
By turning the ignition off and on.
›
By turning voice control off and on.
›
Via the Bluetooth - Visibility menu item in the information display.
Creating a connection with an already paired mobile phone
After switching on the ignition, the connection is automatically established for
the already paired mobile phone
. Check on your mobile phone if the automatic
1)
connection has been established.
Disconnecting the connection
›
By withdrawing the ignition key.
›
By disconnecting the hands-free system in the mobile phone.
›
By disconnecting the user in the Bluetooth - User menu item in the information
display.
Solving connection problems
If the system reports No paired phone found, check the operating status of the
mobile phone.
›
Is the mobile phone switched on?
›
Is the PIN code entered?
›
®
Is Bluetooth
active?
›
Is the visibility of the mobile phone active?
›
Has the mobile phone already been paired with the hands-free system?
1)
Some mobile phones have a menu, in which the authorisation for establishing a Bluetooth
tion is completed by inputting a code. If the authorisation input is required, it must always be per-
formed when re-establishing the Bluetooth connection.
102
Using the system
Note
If a suitable adapter is available for your mobile phone, only use your mobile
■
phone in the adapter inserted in the telephone mount so that the radiation in the
vehicle drops to a minimum.
Placing the mobile phone in the adapter inserted in the telephone mount en-
■
sures optimum sending and receiving power.
Inserting the mobile phone and adapter
First read and observe the introductory information given on page 101.
Only one telephone mount is factory-fitted. An adapter for the mobile phone can
be purchased from ŠKODA Original Accessories.
Inserting the adapter and mobile phone
›
First of all push the adapter
stop into the mount. Then press the adapter slightly downwards, until it locks
securely into position.
›
Insert the mobile phone into the adapter
from the manufacturer of the adapter).
Removing the adapter and mobile phone
›
Simultaneously press the locks on the mount
with the mobile phone.
®
connec-
Fig. 96
Universal telephone preinstalla-
tion
in the direction of the arrow
» Fig. 96
A
(as specified in the instructions
A
» Fig. 96
and remove the adapter
up to the