Table of Contents
Advertisement
Adjusting, removing and installing the head restraints
Fig. 48 Head restraint: adjusting/removing
First read and observe the introductory information and safety warn-
ings
on page 62.
Adjusting the height of a head restraint
›
Grasp the side of the head restraint with both hands and push it upwards as re-
quired
» Fig. 48
- .
›
To move the head restraint downwards, press and hold the safety but-
ton
» Fig. 48
- with one hand and press the head restraint downwards with
the other hand.
Removing and installing a head restraint
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in direction of the arrow
head restraint out.
›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
» Fig. 48
- and pull the
Rear centre head restraint
First read and observe the introductory information and safety warn-
ings
on page 62.
Applies to vehicles using the TOP TETHER system.
Removing/installing
›
Pull the head restraint out of the seat backrest as far as the stop.
›
Press the locking button in the direction of arrow
press the locking button into the opening
width of maximum 5 mm and pull out the head restraint.
›
To re-insert the head restraint, push it far enough down into the seat backrest
until the locking button clicks into place.
Rear seats
Introduction
This chapter contains information on the following subjects:
Fig. 49
Rear seats: middle head re-
straint
» Fig.
49, simultaneously
1
using a flat screwdriver with a
2
63
Seats and stowing
64
64
64
65
65
66
Hide quick links:
Advertisement
Chapters
Table of Contents
