Remote Control Key Memory Function - Skoda Yeti Owner's Manual

Storing exterior mirror setting for reversing
›
Switch on the ignition.
›
Press the required memory button
›
Move the rotary knob for the exterior mirror control into position 
›
Engage reverse gear.
›
Move the right exterior mirror into the desired position
›
Take the vehicle out of gear.
The adjusted position of the exterior mirror is stored in the seat memory.
Retrieving the saved setting
The retrieval is possible when turned the ignition is switched on and the vehicle
speed is less than 5 km/h or when the ignition key is inserted in the ignition lock.
›
Press and hold the desired memory button
Stopping the ongoing adjustment
›
Press any button on the driver's seat.
›
The movement can be stopped by pressing the button
key and opening the driver's door.
Note
Each time new seat and exterior mirror settings for forward travel are saved, the
individual setting for the right exterior mirror for reverse travel must also be
saved again.

Remote control key memory function


First read and observe the introductory information and safety warn-
ings on page 58.
The function of automatically storing the positions of the driver's seat and the
external mirrors when the vehicle is locked can be activated in the memory of
the remote control key.
When this function is activated, the current positions of the driver's seat and the
external mirrors are saved in the memory of the remote control key each time the
vehicle is locked. When the vehicle is next unlocked using the same key, the driv-
er's seat and the external mirrors assume the positions stored in the memory of
this key.
Activating the function
›
Unlock the vehicle with the remote control key.
» Fig. 46.
B
» page
» page 56.
» Fig. 46 for a short while.
B
on the remote control

›
Press and hold any memory button
assumed the position stored under this button, at the same time press the but-
ton on the remote control key within 10 seconds.

56.
The successful activation of the function is confirmed by an audible signal.
The seat and external mirror positions which are already saved in the memory
button are not saved in the memory of the key.
The seat can be adjusted to the required position if necessary
After locking the vehicle, the current positions of the driver's seat and the exter-
nal mirrors are saved in the memory of the remote control key.
Deactivating the function
›
Unlock the vehicle with the remote control key.
›
Press and hold the
SET
the button on the remote control key within 10 seconds.

The successful deactivation of the function is confirmed by an audible signal.
Stopping the ongoing adjustment
›
Press any button on the driver's seat.
›
The movement can be stopped by pressing the button
key and opening the driver's door.
Note

Once the function has been activated, it remains active until deactivation.
» Fig. 46 on page 60. After the seat has
B
button » Fig. 46 on page 60. At the same time, press
A
on the remote control

Seats and stowing
» page 60.

61