Skoda Yeti Owner's Manual page 233

Tail light
Fig. 185 Removing the tail light assembly/disconnecting the plug connec-
tion
Fig. 186 Remove the middle part of the light/tail light: Bulb arrangement

First read and observe the introductory information and safety warn-
ings on page 228.
Overview of the location of the bulbs
- Brake lights
1
- Reversing light
2
- Rear fog light
3
- Turn signal lights
4
- parking lights
5
» Fig. 186.
Removing and installing the tail light
›
Unscrew the light using the Torx key from the car tool kit. The shorter side of
the wrench is used for loosening the screws
for screwing them out completely.
›
Grip the light in the upper and lower area and move backwards somewhat.
›
Disconnect the plug connection by pressing the catches in direction of arrow
» Fig. 185 and by pulling them in direction of arrow
2
›
Unscrew the securing screw » Fig. 186
A
press the three catches in direction of arrow. Remove the plastic lamp holder.
›
When reinstalling, insert the plastic lamp holder into the tail light until the
catches audibly engage and insert the securing screw
›
Reconnect the plug connection and put the light into the original position.
›
Screw the light with the screws
Replacing the bulbs on the tail light
›
To replace the lamp , , or
1 2 3
wise as far as it goes and remove it from the housing or remove the lamp
from the socket.
›
Replace the lamp, insert the socket with the bulb into the housing and insert/
turn in a clockwise direction as far as it goes.
» Fig. 185 and the longer side
1
.
3
with the aid of the Torx wrench and
with the Torx key.
A
» Fig. 185 into place.
1
» Fig. 186 turn the lamp socket anti- clock-
4
Fuses and light bulbs
5

231