Ignition Lock - Skoda Yeti Owner's Manual

Electronic immobiliser

First read and observe the introductory information and safety warn-
ings on page 116.
An electronic chip is integrated in the head of the key. The immobiliser is deacti-
vated with the aid of this chip when the key is inserted in the ignition lock. The
electronic immobiliser is automatically activated when the ignition key is with-
drawn from the lock.
The engine will not start if a non-authorized ignition key is used.
The following is displayed in the information display:
Immobilizer active.

Ignition lock


First read and observe the introductory information and safety warn-
ings on page 116.
Petrol engines
Ignition switched off, engine off, the steering can be locked
1
Ignition switched on
2
Starting engine
3
Diesel engines
1 Fuel supply interrupted, ignition switched off, engine switched off, the steer-
ing can be locked.
Heating glow plugs on, ignition switched on
2
Starting engine
3
118
Driving
Fig. 102
Positions of the vehicle key in
the ignition lock
To lock the steering, with the ignition key withdrawn, turn the steering wheel
until the steering locking pin engages audibly.
If the steering is locked and the key cannot or can only be turned with difficulty
into the position » Fig. 102, move the steering wheel back and forth and the
2
steering lock will unlock.
Starting the engine

First read and observe the introductory information and safety warn-
ings on page 116.
Vehicles with a diesel engine are equipped with a glow plug system. The pre-

glow indicator light comes on after the ignition has been switched on. The en-

gine should be started immediately after the preglow indicator light goes out.
You should not switch on any major electrical components during the heating
period otherwise the vehicle battery will be drained unnecessarily.
Procedure for starting the engine
›
Before starting the engine, place the gearshift lever into neutral or place the se-
lector lever in the position P or N and firmly put on the handbrake.
›
Fully depress and hold the clutch pedal, switch on the ignition
page 118 and start - do not operate the accelerator. Depress the clutch pedal
3
until the engine starts.
›
Let go of the key as soon as the engine starts. After letting go, the vehicle key
will return to position .
2
›
If the engine does not start within 10 seconds, abort the start-up process and
turn the key to position . Repeat the start-up process after approx. half a mi-
1
nute.
›
Release the handbrake before starting off.
The engine will not start if the clutch pedal is not depressed.
The following is displayed in the information display:
Depress clutch to start!
The following is shown in the information display of the information cluster:
CLUTCH

» Fig. 102 on
2
