Skoda Yeti Owner's Manual page 16

The display appears in litres/hour if the vehicle is stationary or driving at a low
speed .
1)
Average fuel consumption
The average fuel consumption since the memory was last erased is shown in the
display in litres/100 km » page 12.
2)
To determine the average fuel consumption over a certain period of time, set the
memory at the start of the new measurement to zero using button
page 13 or with the adjustment wheel
first 100 m you drive after erasing the memory.
The display is updated regularly while you are driving.
Range
The estimated range in kilometres is shown on the display. It indicates the dis-
tance you can still drive with your vehicle based on the level of fuel in the tank
and the same style of driving.
The display is shown in steps of 10 km. Once the fuel gauge pointer reaches the
reserve marking, the range is displayed in 5 km.
The fuel consumption over the last 50 km is used to calculate the range. The
range will increase if you drive in a more economical manner.
If the memory is set to zero (after disconnecting the battery), the fuel consump-
tion of 10 ltr./100 km is calculated for the range; afterwards the value is adapted
accordingly to the style of driving.
Distance travelled
The distance driven since the memory was last erased appears in the dis-
play » page 12. If you wish to measure the distance travelled from a particular
point in time, you need to set the memory to zero at this point in time by pressing
the button » Fig. 6 on page 13 or the adjustment wheel
B
The maximum distance indicated in both memories is 1 999 km or 9 999 km on
vehicles with an information display. The indicator is set back to zero if this period
is exceeded.
1)
On some models in certain countries, the display appears in --,- kilometres/litres if the vehicle is sta-
tionary.
2)
On some models in certain countries, the display appears in kilometres/litre.
14
Using the system
» Fig. 6
B
. Dashes appears in the display for the
D
.
D
Average speed
The average speed since the memory was last erased is shown in the display in
km/hour » page 12. If you wish to determine the average speed over a certain pe-
riod of time, you need to set the memory to zero at the start of the measurement
using the button » Fig. 6
B
A zero appears in the display for the first approx. 300 m you drive after erasing
the memory.
on
The display is updated regularly while you are driving.
Current speed
The current speed which is identical to the display of the speedometer
on page 8 is indicated on the display.
Oil temperature
If the oil temperature is lower than 50 °C or if a fault in the system for checking
the oil temperature is present, only - -.- is displayed instead of the oil tempera-
ture.
Warning against excessive speeds

First read and observe the introductory information and safety warn-
ings on page 12.
Adjust the speed limit while the vehicle is stationary
›
Press button » Fig. 6
A
item Speed warn.
›
Press the button » Fig. 6
B
the ability to set the speed limit (value flashes).
›
Press button or turn adjustment wheel
A
50 km/h.
›
Use the button or the adjustment wheel
B
wait approx. 5 seconds and the setting is saved automatically (the value stops
flashing).
This allows you to set the speed in 5 km/h intervals.
on page 13 or the adjustment wheel
on page 13 or turn adjustment wheel
on page 13 or the adjustment wheel
to set the desired speed limit, e.g.
D
to confirm the set speed limit, or
D
.
D
» Fig. 2
2

to select menu
D
to activate
D
