Memory Function Of The Remote Control Key; B » Fig - Skoda Octavia Owner's Manual

Saving front passenger mirror settings when reversing
The function of the lowering of the passenger-side mirror surface must be en-
abled in infotainment » Bedienungsanleitung Infotainment, chapter Vehicle
settings (button CAR).
›
Switch on the ignition.
›
Press the required memory button
›
Adjust the rotary knob for the mirrors to the position  or in right-hand drive
to the position  » page 83.
›
Engage reverse gear.
›
Adjust the front passenger's mirror to the desired position
›
Disengage reverse gear.
The set position of the exterior mirror is stored.
Retrieving the saved setting
›
Tap the desired memory button
off and the driver's door is opened.
Or
›
Press down on the desired memory button
on and the driver's door is closed.
Stopping the ongoing adjustment
›
Press any button on the driver's seat.
Or
›
Press the button on the remote control key.

Note
Each time you store the seat and exterior mirror settings for driving forward
you also have to re-store the setting of the exterior mirror on the passenger
side for reversing.

Memory function of the remote control key


Read and observe on page 85 first.
The automatic storage of the driver's seat and exterior mirror positions when
locking the vehicle can be turned on in the memory of the remote control key
(afterwards only as function of automatic storage).
1) The vehicle must be locked and unlocked with the same key to save the seat and exterior mirror position
to the key.
88
Using the system
» Fig. 69.
B
» page
» Fig. 69 when the ignition is switched
B
when the ignition is switched
B
This function can also be activated or deactivated in the Infotainment
nungsanleitung Infotainment, chapter Vehicle settings (CAR button)..
Enable automatic storage
›
Unlock the vehicle with the remote control key.
›
Press and hold any memory button
has assumed the position stored under this button, at the same time press
the button on the remote control key within 10 seconds.

The successful activation of the automatic storage function for each key is
confirmed by an acoustic signal.
83.
Storing seat and exterior mirror settings for driving forward
›
Enable automatic storage.
When automatic storage is activated, the current positions of the driver's seat
and the external mirrors are saved in the memory of the remote control key
each time the vehicle is locked. When the vehicle is next unlocked using the
same key, the driver's seat and the external mirrors assume the positions stor-
ed in the memory of this key
Saving front passenger mirror settings when reversing
The function of the lowering of the passenger-side mirror surface must be en-
abled in infotainment
settings (button CAR).
›
Unlock the vehicle with the remote control key.
›
Switch on the ignition.
›
Adjust the rotary knob for the mirrors to the position  or in right-hand drive
to the position 
›
Engage reverse gear.
›
Adjust the front passenger's mirror to the desired position
›
Disengage reverse gear.
The adjusted position of the exterior mirror is stored in the remote control key
memory.
Disable the function of automatic storage
›
Unlock the vehicle with the remote control key.
›
Press and hold the
press the button
» Fig. 69 on page 87. After the seat
B
.
1)
» Bedienungsanleitung Infotainment, chapter Vehicle
» page 83.
button » Fig. 69 on page 87. At the same time,
SET A
on the remote control key within 10 seconds.

» Bedie-
» page 83.
