Level Check; Braking System - Gilera 2008 MSS Nexus User Manual

MSS Nexus 300 i.e. E3 ( 2008)
Cooling system
approx. 1.8 litres

Level check

Check coolant level when the engine is cold and
as indicated in the scheduled maintenance table,
following the steps below:
- Place the vehicle on its centre stand and on flat
ground.
- Remove the expansion tank cap.
- To check the level, it is necessary to look inside
the expansion tank:
Reference «C» shows the adequate coolant level.
-The coolant consists of an ethylene glycol and corrosion inhibitor based 50% de-ionised water- anti-
freeze solution mix.
CAUTION
DO NOT EXCEED THE MAX. LEVEL WHEN FILLING SO AS TO AVOID THE COOLANT ESCAPING
FROM THE EXPANSION TANK WHEN THE vehicle IS IN USE.
N.B.
THE COOLANT CONSISTS OF A MIXTURE OF DE-IONISED WATER AND FLUID FOR SEALED
CIRCUITS. THE MIXTURE THUS OBTAINED LOWERS THE FREEZING POINT OF THE COOLANT
TO - 40°C. THE MIXTURE IN COMBINATION WITH THE PRESSURE OF 0.9 BAR RAISES THE
BOILING POINT TO APPROX. 125°C. THE RECOMMENDED LIQUID ALSO PROVIDES PROTEC-
TIVE FUNCTIONS FOR THE ALUMINIUM ALLOYS. THIS CHARACTERISTIC MAY DECREASE
OVER THE COURSE OF TIME; THIS IS WHY A PERIODIC REPLACEMENT OF THE COOLANT IS
INDISPENSABLE.
N.B.
FOR THE REPLACEMENT OF THE COOLANT AND THE FLUSHING OF THE SYSTEM, SEE
CHAPTER COOLING SYSTEM.

Braking system

Level check
- Position the vehicle on a flat surface and on the
centre stand.
- Check the brake fluid level via the special indi-
cator located on the pump.
N.B.
Maintenance
MAIN - 49