Gilera 2008 MSS Nexus User Manual page 65

MSS Nexus 300 i.e. E3 ( 2008)
Electrical system
keys. The master and service keys must be used
to code the system as follows:
- Insert the Master key, turn it to «ON» and keep
this position for two seconds (limit values 1 to 3
seconds).
- Insert the service key and turn it to «ON» for 2
seconds.
- If you have copies of the key, repeat the operation
with each key.
- Insert the MASTER key again and turn it to «ON»
for 2 seconds.
The maximum time to change keys is 10 seconds.
A maximum of 7 service keys can be programmed
at one time.
It is essential to adhere to the times and the pro-
cedure. If you do not, start again from the begin-
ning. Once the system has been programmed, the
master key transponder is strictly matched with the
control unit. With this link established, it is now
possible to encode new service keys, in the event
of losses, replacements, etc. Each new program-
ming deletes the previous one so, in order to add
or eliminate keys, you must repeat the procedure
using all the keys you intend to keep using. If a
service key becomes uncoded, the efficiency of
the high voltage circuit shielding must be thor-
oughly inspected: In any case it is advisable to use
resistive spark plugs.
Characteristic
MASTER key:
RED KEY
SERVICE key.
BLACK KEY
ELE SYS - 65