Removing The Intake Manifold - Gilera 2008 MSS Nexus User Manual

Engine
- Using the special flywheel stop tool, tighten up
the flywheel fixing nut to the prescribed torque
-Refit the retention plate
Specific tooling
020627Y Flywheel lock wrench
Locking torques (N*m)
Flywheel nut
94 ÷ 102
Refitting the starter motor
- Fit a new O-ring on the starter motor and lubricate
it.
- Fit the starter on the crankcase, locking the two
screws to the prescribed torque.
Locking torques (N*m)
Starter motor screws
Cylinder assy. and timing system

Removing the intake manifold

Loosen the three screws and remove the air intake manifold.
- When refitting, secure to the specified torque.
ENG - 124
11 ÷ 13
MSS Nexus 300 i.e. E3 ( 2008)