Gilera 2008 MSS Nexus User Manual page 217

MSS Nexus 300 i.e. E3 ( 2008)
Suspensions
- remove the spring anchoring the swinging arm to
the frame as shown in the photo
- Remove the two screws fixing the buffer support
bracket to the frame
- Undo the nut on the LHS shown in the figure and
remove the corresponding bolt from the opposite
side.
- Remove the swinging arm.
- Check the entire swinging arm assembly.
- Check all the centring bushing components and
silent block rubber buffers.
- Replace the work components that cause exces-
sive clearance on the rear suspension.
SUSP - 217