Electrical system
- With the engine off and the panel at «ON» with the lights on, allow the battery voltage to stop at 12V.
- Connect ammeter pliers to the 2 recharge positive poles in output from the regulator.
- Start the engine and rev it up to a high engine speed while reading the value on the pincer.
With an efficient battery a value must be detected: > 20A
Specification
Voltage
Starter motor
KEY
1. Battery
2. Fuse No. 3
3. Key switch contacts
4. Fuse No. 10
5. Stop buttons
6. Starter button
7. Starter motor
8. Start-up remote control
A. To injection ECU
WARNING
ALL CONTINUITY TESTS MUST BE CARRIED OUT WITH THE CORRESPONDING CONNECTORS
DISCONNECTED.
ELE SYS - 70
VOLTAGE REGULATOR/RECTIFIER
Type
MSS Nexus 300 i.e. E3 ( 2008)
Desc./Quantity
Non-adjustable three-phase transistor
14 ÷ 15V at 5000 rpm with lights off