Gilera 2008 MSS Nexus User Manual page 254

Chassis
Removing the ignition key-switch when on *off*
- Remove the lower shield back plate.
- Unscrew the seat opening transmission from the
side.
- Remove in advance the ring of the immobiliser
antenna.
- Loosen the 2 hex. socket head screws and re-
move the complete switch.
- From the underside it is possible to loosen the 3
retaining screws and to release the 2 locking tabs
to raise the mounting plate of the steering lock
strut.
- The latter has a retaining tab with cylindrical teeth
that cannot be replaced.
Front wheel housing
To remove the front wheel housing, proceed as
follows:
- Remove the spoiler.
- Remove the front fork.
- Remove the plate supporting bracket for the horn
and voltage regulator by loosening the two fixing
screws shown in the figure in order to release the
two lower retainers of the wheel housing.
- Remove the upper fixing screw of the wheel
housing to permit movement.
CHAS - 254
MSS Nexus 300 i.e. E3 ( 2008)