Front Brake Calliper - Gilera 2008 MSS Nexus User Manual

MSS Nexus 300 i.e. E3 ( 2008)
- Hold the pads in the correct position and insert the calliper in the brake disc.
- Fix the support calliper by means of the two screws at the specified torque
- Secure the pipe fitting to the calliper at the specified torque.
- Bleed the air from the system.
Locking torques (N*m)
Rear brake calliper fixing screws 20 ÷ 25 Engine- calliper support plate fixing screws 48 ÷ 52

Front brake calliper

Removal
- Remove the two front brake calliper devices fas-
tening them to the support as shown in the photo-
graph.
N.B.
WHEN A PROCEDURE IS PLANNED INCLUDING THE
SERVICE OR REPLACEMENT OF THE CALLIPER, FIRST
LOOSEN THE FITTING CONNECTING THE PIPE TO THE
BRAKE CALLIPER
Overhaul
- Remove the brake calliper.
- Suitably support the brake calliper in a vice
- Remove the two pad fixing screws.
- Remove the pads being careful with the stop
spring.
- Remove the fixed plate by undoing the screw
shown in the photograph.
Braking system
BRAK SYS - 227