MSS Nexus 300 i.e. E3 ( 2008)
Centre-stand
REMOVAL
- Use a jack to support the vehicle properly.
- Remove the two return springs from the centre
stand.
- Undo the nut shown in the figure.
- Remove the bolt from the right side.
- Remove the centre stand.
FITTING
- On refitting tighten the nut to the specified torque.
Locking torques (N*m)
Centre stand bolt
32 ÷ 40
Side stand
REMOVAL
- Uncouple the centre stand return spring;
Remove the screw shown in the photograph
FITTING
To refit, carry out the removal operations in re-
verse order and comply with the specified torque.
Locking torques (N*m)
Side stand fixing bolt
35 ÷ 40
Suspensions
SUSP - 223