Gilera 2008 MSS Nexus User Manual page 50

Maintenance
THE LEVEL TENDS TO DROP AS THE BRAKE PADS GET WORN, A MINIMUM LEVEL SHOULD
NOT BE REACHED. IF THE LEVEL IS TOO LOW, CHECK AND FIX THE SYSTEM SEALS, IF RE-
QUIRED. TOP UP THE PUMP TANK, IF REQUIRED, CONSIDERING THAT THE "MAX." LEVEL
MUST ONLY BE OBTAINED WITH NEW PADS.
Top-up
CAUTION
ONLY USE DOT 4-CLASSIFIED BRAKE FLUID.
Proceed as follows:
- Position the vehicle on a flat surface and on the
centre stand.
- Remove the tank cap by removing the two
screws, remove the gasket and top up using only
the liquid specified without exceeding the maxi-
mum level.
CAUTION
AVOID CONTACT OF THE BRAKE FLUID WITH YOUR EYES, SKIN, AND CLOTHING. IN CASE
OF ACCIDENTAL CONTACT, WASH WITH WATER.
WARNING
BRAKE CIRCUIT FLUID IS VERY CORROSIVE; DO NOT LET IT COME INTO CONTACT WITH
PAINTED PARTS.
WARNING
THE BRAKE FLUID IS HYGROSCOPIC, THAT IS, IT ABSORBS MOISTURE FROM THE SUR-
ROUNDING AIR. IF THE HUMIDITY IN THE BRAKING FLUID EXCEEDS A CERTAIN VALUE, IT
WILL LEAD TO INEFFICIENT BRAKING; FOR THIS REASON, NEVER USE BRAKING FLUID
FROM CONTAINERS THAT HAVE ALREADY BEEN OPENED, OR PARTIALLY USED.
Recommended products
AGIP BRAKE 4 Brake fluid
FMVSS DOT 4 Synthetic fluid
Under standard climatic conditions, replace coolant as indicated in the scheduled maintenance table.
N.B.
MAIN - 50
MSS Nexus 300 i.e. E3 ( 2008)