Rear Brake Calliper - Gilera 2008 MSS Nexus User Manual

MSS Nexus 300 i.e. E3 ( 2008)
This section è is devoted to the description of the braking system components.

Rear brake calliper

Removal
- Remove the rear wheel.
- Remove the two rear brake calliper devices fas-
tening them to the support as shown in the photo-
graph.
N.B.
SHOULD THE BRAKE CALLIPER BE REPLACED OR
SERVICED, BEFORE REMOVING THE FITTINGS FIXING
THE CALLIPER TO THE SUPPORT BRACKET, LOOSEN
THE OIL HOSE FITTING AFTER HAVING EMPTIED THE
SYSTEM OF THE CIRCUIT BEING EXAMINED.
Overhaul
- Remove the brake calliper.
- Suitably support the brake calliper in a vice
- Remove the two pad fixing screws.
- Remove the pads being careful with the stop
spring.
- Remove the fixed plate by undoing the screw
shown in the photograph.
Braking system
BRAK SYS - 225