Rear Cover, Side Cover (L) Assembly, Face-Up Stacker - OKIDATA Okipage 16n Service Manual

Page: 26
Service Guide OKIPAGE16n
Chapter 3 Parts Replacement
3.3.1 Rear cover, side cover (L) Assembly, face-up stacker Assembly, and I/F cover Assembly.
(1) Turn the AC power switch off. Unplug the AC power cord from the outlet.
(2) Remove the interface cable 1. Remove drum/toner Assembly (see picture below) and store in black
plastic bag shipped w/printer.
(3) Open the face-up stacker Assembly 8. Disconnect the engagement at the left and right
protrusions 8A . Remove the face-up stacker Assembly 8. (Flex the Assembly 8 in the
middle to disengage 8A from the Rear cover 0.)
(4) Open the stacker cover 2 and the manual feed hopper Assembly3. Remove three screws
4. Remove the side cover (L) Assembly 5.
(5) Remove two screws 6. Remove the I/F cover Assembly 7.
(6) Remove two screws 9 and four claws A. (Use a small flat blade screw driver to "pop" claws.)
Remove the rear cover 10.