C External Floppy Disk Drive (Usb) Notes On Usage - Fujitsu PRIMERGY BX620 S4 User Manual

C External Floppy Disk Drive (USB)
Notes on Usage
The section explains notes on the usage of USB connected floppy disk drive.
Notes on floppy disk drive recognition at server startup
If the floppy disk drive (USB), with a floppy disk inserted, is not connected at server startup, BIOS
cannot recognize the floppy disk drive (USB). When installing Windows/Linux, or when using
Windows Server 2003 Automatic System Recovery (ASR), make sure to connect the floppy disk drive
(USB) with a floppy disk inserted before server startup.
Notes on floppy disk media exchange recognition when installing
windows manually and at system recovery
When performing system recovery using Windows Server 2003 Automatic System Recovery (ASR),
also when installing Windows manually, system recovery/installation might not be performed properly.
This is caused by the device driver being unreadable due to recognition failure of the floppy disk media
replacement.
After pressing the [Enter] key in accordance with the procedures on the screen, if the floppy disk access
LED on the floppy disk drive (USB) does not turn on and the floppy disk is not accessed, follow the
procedures below.
1
Eject the floppy disk and wait for 2 seconds or longer, then press the [Enter] key
several times.
2
Insert the floppy disk and wait for 2 seconds or longer, then press the [Enter]
key.
If the floppy disk cannot be accessed, perform the procedures above again.
PRIMERGY BX620 S4 Server Blade User's Guide
267