Fujitsu PRIMERGY BX620 S4 User Manual page 37

Setting the time synchronization function with the Management Blade
To set the time synchronization function with the Management Blade, select "Sync RTC with Mgnt.
Blade" in the [Main] menu on the BIOS Setup Utility, and specify the time synchronization function.
"8.2.2 Main Menu" (pg.208)
Using an USB CD/DVD drive (change of device priority sequence)
When using the USB CD/DVD drive, change the device priority sequence in the [Boot] menu of the
BIOS Setup Utility.
For more details about changing the boot drive, refer to "8.2.15 Boot Device Priority Submenu"
( pg.225).
1st Boot Device
2nd Boot Device
3rd Boot Device
4th Boot Device
5th Boot Device
Booting the Server Blade with PXE
Before Booting the Server Blade with PXE, use the following procedures to enable network startup
(PXE). In addition, check the MAC address.
When booting the Server Blade with PXE, turn on the Server Blade power one minute or more after the
main power of the Chassis was turned on. Turning on the Server Blade power just after the main
power was turned on may cause PXE not to boot due to the Switch Blade not having been started.
The PXE boot function is not available for the LAN port of the 1 Gbit/s Ethernet I/O Module.
1
Take the following steps in the BIOS Setup Utility.
Set PXE (IBA CE slot nnnn v) to the highest level in the boot priority sequence.
For more details about changing the boot drive, refer to "8.2.15 Boot Device Priority Submenu"
( pg.225).
The boot priority sequence can be changed from Web UI or CLI for the Management Blade.
Refer to "BX600 Management Blade Hardware Guide".
2
Check the MAC address.
After BIOS setup, start up the server from the network.
After POST was completed, the MAC address is displayed as shown below.
CLIENT MAC ADDR: ** ** ** ** ** **
3
Turn off the server.
You can confirm that the server is turned off using "Deployment Parameter" for Web UI and
CLI, and "Server Blade MAC Address Table" for CLI of the Management Blades. For details,
refer to "BX600 Management Blade Hardware Guide".
PRIMERGY BX620 S4 Server Blade User's Guide
[Y-E USB-FDU]
[CENERIC CDR****]
[#520 ID00 LUN0 ***] (When an expansion card slot
[IBA CE Slot **** v]
[IBA CE Slot **** v]
module is not installed)
37