Server Blade - Fujitsu PRIMERGY BX620 S4 User Manual

Chapter 9 Operation and Maintenance

Server Blade

The Server Blade will not turn on, or the power LED on the front of the Server
Blade does not light up
• Check whether the Server Blade is securely installed in the Server Blade slot of the Chassis.
• Check whether the main power of the Chassis is turned on.
• Check to see whether the power cable of the Chassis is properly connected to the outlet.
For details, refer to the "Start Guide".
The Server Blade will not turn on, or the KVM select LED blinks
Check whether the number of installed Server Blades exceeds the limit
For details, refer to "4.2 Installing Server Blades/Storage Blades" in "BX600 S3 Blade Server System
Unit Hardware Guide".
The hard disk access LED does not light up
The Server Blade may be damaged. Contact an office listed in the "Contact Information" of the "Start
Guide".
When contacting an office listed in the "Contact Information" of the "Start Guide", refer to "9.8.2
Contacting Maintenance Support" ( pg.259) and collect the required information.
An error message is displayed
Refer to "9.2.2 Error Messages" ( pg.234).
The LAN does not operate properly
The Switch Blade may not be running properly. Check the Switch Blade settings.
Switch Blade
If there is a problem with network connection, first check the wiring and confirm that the device is
normally connected to network.
If the error still occurs, refer to the following.
Switch indicator diagnosis
There is a device connected to a port of the Switch Blade, but the link LED is
off
• Check that the Switch Blade and connected device are turned on.
• Check that the cable is connected to both the Switch Blade and device.
• Check that the cable type is appropriate and the cable length does not exceed the allowable range.
• Check that there are no defects in the connection between the cable and adapter of the connected
device. Replace the defective cable or adapter as required.
• Check that all the system components are installed correctly. If the network cable does not function
normally, execute a test in an environment where all the components other than the cable function
normally.
230