Replacing The Floppy Disk Drive - Fujitsu PRIMERGY Econel 50 Service Supplement Manual

Replacement Routines
4.3

Replacing the Floppy Disk Drive

Ê Remove the left side cover and the front panel as described in section
"General Purposes" on page 13.
Ê Disconnect the power supply cable (connector P4) from the floppy disk drive.
Ê Disconnect the data cable T26139-Y1248-V8 from the floppy disk drive.
Ê Detach the USB connector cable T26139-Y3894-V2 from the connector
USB1/2 on the system board (see D1859 sticker).
Figure 6: Removing the slide-in unit with floppy disk drive
Ê Press together the two springs of the EasyClick rails until they are
unlocked (1).
Ê Remove the slide-in unit with the floppy disk drive from the location (2).
Econel 50
Replacing the Floppy Disk Drive
1
Service Supplement
1
2
19