Fujitsu PRIMERGY BX620 S4 User Manual page 28

Chapter 1 Overview
• Hard disk status LED (Right)
This LED lights or blinks depending on the hard disk status described below.
Off
Lights amber
Flashes amber
Flickers amber
d Server blade power LED ( )
It is lit or blinks depending on the Server Blade power status as follows.
LED status
Off
Lights green
Lights amber
Blinks green
Blinks amber
Blinks green-amber
e Server blade power switch
Press this switch to turn the Server Blade on.
For the procedure to turn the Server Blade on/off, refer to the "BX600 S3 Blade Server System
Unit Hardware Guide".
f KVM select LED ( )
It is lit or blinks depending on the KVM status as follows.
LED status
Off
Lights green
Blinks amber
28
table: Hard disk status LED
LED status
Normal mode
Error detected in the hard disk
Displaying the running hard disk using SAS BIOS Utility
Rebuilding
table: Server blade power LED
The power is not supplied to the Server Blades.
(The Chassis power is not turned on.)
The power is turned on.
The power is turned off. (Standby)
Blinks when an error is detected in the Server Blade or the Server Blade
identification function is used while the power is turned on.
If an error occurs, contact an office listed in the "Contact Information" of
"Start Guide" or device administrator.
Blinks when an error is detected in the Server Blade or the Server Blade
identification function is used while the power is turned off.
If an error occurs, contact an office listed in the "Contact Information" of
"Start Guide" or device administrator.
Standby mode. (ACPI function)
The Server Blade does not support this mode.
When the hard disk access display LED lights, do not turn off the power. Data in the hard disk
may be damaged.
table: KVM select LED
KVM is not selected.
KVM is selected.
Blinks when a BMC
the maximum installable number for the Server Blades was exceeded.
In this case, contact an office listed in the "Contact Information" of "Start
Guide" or device administrator.
Description
Description
Description
*1
error was detected without KVM selected, or when