System Event Log; Server Management Tools - Fujitsu PRIMERGY BX620 S4 User Manual

9.3 System Event Log

To operate system event log, use Server Management Tools
This section explains how to use Server Management Tools.
The server settings are set so that when the System event log area in the server becomes full a new
event log is automatically written over the old log areas.

9.3.1 Server Management Tools

Server Management Tools perform the following to the system event log stored in the Baseboard
Management Controller (BMC: a micro-controller used for managing the baseboard environment, such
as its temperature and voltage sensors).
• Viewing the system event log
• Saving the system event log
• Deleting the system event log
When an system event log occurs, save the log using Server Management Tools and contact an office
listed in the "Contact Information" in the "Start Guide".
The system event log of this Server Blade can be viewed from the management terminal via the
Management Blade.
→ "BX600 Management Blade Hardware Guide".
The "Server Management Tools" disk is for this Server Blade only. Do not use those tools on other
systems. If it is used, the system may be damaged.
To execute the Server Management Tools, follow the startup procedure shown in "9.3.2 Starting and
Exiting Server Management Tools" ( pg.244) to start the Server Blade. Do not run this tool on the
server started from the hard disk drive or other floppy disks. Otherwise, the system may be corrupted.
Do not eject the floppy disk when the floppy disk access LED is on. Doing so may destroy the data on
the floppy disk.
PRIMERGY BX620 S4 Server Blade User's Guide
243