Fujitsu PRIMERGY BX620 S4 User Manual page 218

Chapter 8 Hardware Configuration/Utilities
Item
OS Boot Watchdog Timer
Timer Count Down Value
Timer Count Action
218
table: Items on the ASR&R Submenu
Setting
• Disabled (Initial value)
• Enabled
• 2 Minutes
• 5 Minutes
• 10 Minutes
(Initial value)
• 15 Minutes
• 20 Minutes
• 30 Minutes
• 60 Minutes
• 100 Minutes
• No Action
• Reset (Initial value)
• Power Off
• Power Cycle
Description
Sets whether to enable or disable the OS Boot
Monitoring function, when ServerView is installed
to the OS.
If for some reason booting the operating system is
interrupted when this function is enabled, the
system will automatically restart.
The OS Boot Monitoring function can also be
enabled or disabled from ServerView.
Note:
If ServerView is not installed to the OS, be
sure to set the OS Boot Watchdog Timer to
[Disabled]. If the setting is set to [Enabled],
the server may automatically turn off or
restart unexpectedly.
Even when ServerView is installed on the
OS, if starting the system while the "Server
Management Tools" disk is inserted, be sure
to disable the "OS Boot Monitoring" function.
If the system is started with this function
enabled, the server may automatically turn
off or restart improperly.
If the OS Boot Monitoring function is
needed, it should be reset to enabled before
resuming normal server operation.
When setting this function, refer to
"ServerView User's Guide" to fully learn
about its specifications, in order to use it
properly with the correct settings.
Sets the monitoring time of the "OS Boot
Monitoring" function.
This item appears when [OS Boot Watchdog Timer]
is set to [Enabled].
Sets the operation when the OS did not boot
successfully within the time set with the [Timer
Count Down Value] setting.
This item appears when [OS Boot Watchdog Timer]
is set to [Enabled].
• No Action: Takes no action.
• Reset: Restarts the system.
• Power Off: urns the server off.
• Power Cycle: Turns the server off and back on
again.