Notes On A Multiple Lan Adapter Configuration; Cautions For Using Serverstart - Fujitsu PRIMERGY BX620 S4 User Manual

RAID configuration
Array controllers to be used vary. For RAID configuration, refer to the respective manuals.
When using an onboard SAS Ctrl (Integrated Mirroring SAS)
Configure RAID with an internal hard disk unit which is connected to a SAS Ctrl.
The array controller to be employed is "Integrated Mirroring SAS" and available RAID level is
"RAID1" only. For details, refer to "Integrated Mirroring SAS User's Guide" in the Array Controller
Document & Tool CD.
When using a SAS RAID Ctrl (MegaRAID SAS)
Configure RAID with a Storage Blade which is connected to a SAS RAID Ctrl.
The array controller to be employed is "MegaRAID SAS" and available RAID level is "RAID0 /
RAID1/ RAID1+0 / RAID5/ RAID6".
For details, refer to "MegaRAID SAS User's Guide" in the Array Controller Document & Tool CD.

2.3.3 Notes on a Multiple LAN Adapter Configuration

Using the OS installation wizard of ServerStart, you can configure multiple LAN adapters (network
adapters) on the system. However, there are the following limitations.
Adapter numbers
To configure multiple LAN adapters (PG-2861L/PG-LND201, etc.), select the adapter numbers in order
of Adapter 1 and Adapter 2, and enter settings for each adapter. Note that the order of adapter numbers is
not necessarily the same as the onboard LAN port numbers. This means that the setting for Adapter 1 is
not always applied to LAN port 1 of the onboard LAN. After installing the OS, check the LAN adapters
to make sure that they are configured as intended.

2.3.4 Cautions for Using ServerStart

Observe the cautions described below when the OS installation is performed with ServerStart.
Operating ServerStart
Mainly, a mouse is used for ServerStart operations. In some cases, operation with the [Tab] key or cursor
are not available. Be sure to use a mouse while operating ServerStart.
PRIMERGY BX620 S4 Server Blade User's Guide
43