Replacing The Primary Ide Cable Assembly; Removing The Secondary Ide Cable Assembly; Figure 6-4 Removing And Replacing The Primary Ide Cable Assembly - Sun Microsystems Sun Blade 100 Service Manual

CD-DVD-ROM
FIGURE 6-4
6.2.6

Replacing the Primary IDE Cable Assembly

1. Position the primary IDE cable assembly into the chassis (
2. Connect the primary IDE cable assembly connectors to the following:
Primary hard drive
CD-ROM or DVD-ROM drive
Riser board (J504: also labeled IDE1)
Note – Ensure that the cable assembly connectors are properly oriented by aligning
the connector keys.
3. Detach the wrist strap, replace the system cover, and power on the system as
described in Chapter 9 "Finishing Component Replacement."
6.2.7

Removing the Secondary IDE Cable Assembly

The secondary IDE cable assembly connects the optional secondary hard drive to the
system.
1. Power off the system, remove the system cover, and attach an antistatic wrist strap
as described in Chapter 5 "Preparing for Component Removal and Replacement."
Removing and Replacing the Primary IDE Cable Assembly
Chapter 6
IDE 1 (J504)
FIGURE 6-4
Removing and Replacing Major Subassemblies
).
6-7