Replacing The Smart Card Reader; Figure 7-2 Removing And Replacing The Smart Card Reader - Sun Microsystems Sun Blade 100 Service Manual

3. If there is a smart card in the reader, remove the smart card.
4. Disconnect the following:
Smart card reader cable
Diskette drive power cable
Diskette drive data cable
5. Using a No. 2 Phillips screwdriver, loosen (but do not remove) the three screws
securing the peripheral assembly to the chassis (
Note – Do not remove the three screws securing the peripheral assembly to the
chassis.
6. Slide the peripheral assembly to the rear of the chassis and lift it from the chassis.
7. Using a No. 2 Phillips screwdriver, remove the three screws securing the smart
card reader to the peripheral assembly (
FIGURE 7-2
8. Remove the smart card reader from the peripheral assembly.
7.2.2

Replacing the Smart Card Reader

1. Slide the smart card reader into the peripheral assembly.
7-4 Sun Blade 100 Service Manual • October 2000
Removing and Replacing the Smart Card Reader
).
FIGURE 7-1
).
FIGURE 7-2