Video Diagnostic; All Above Diagnostic - Sun Microsystems Sun Blade 100 Service Manual

4.7.2.12

Video Diagnostic

To start the video diagnostic, type
diagnostic validates the graphics.
The following code example shows the video diagnostic output message.
CODE EXAMPLE 4-18
Enter (0-13 tests, 14 -Quit, 15 -Menu) ===> 12
TEST='video_test'
Please connect the monitor and use ttya/ttyb when running this test
if you are using the screen it may be become unreadable
SUBTEST='mach64-chip-id-vendor-id-check'
SUBTEST='video-frame-buffer-test'
SUBTEST='mach64-walk-one-test'
SUBTEST='mach64-walk-zero-test'
Enter (0-13 tests, 14 -Quit, 15 -Menu) ===>
4.7.2.13

All Above Diagnostic

To start the all above diagnostic, type
diagnostic validates the entire system.
The following code example shows the all above diagnostic output message.
CODE EXAMPLE 4-19
Enter (0-13 tests, 14 -Quit, 15 -Menu) ===> 13
TEST='all_pci/cheerio_test'
SUBTEST='vendor_id_test'
SUBTEST='device_id_test'
SUBTEST='mixmode_read'
SUBTEST='e2_class_test'
SUBTEST='status_reg_walk1'
SUBTEST='line_size_walk1'
SUBTEST='latency_walk1'
SUBTEST='line_walk1'
SUBTEST='pin_test'
TEST='all_dma/ebus_test'
SUBTEST='dma_reg_test'
SUBTEST='dma_func_test'
4-22 Sun Blade 100 Service Manual • October 2000
at the OBdiag Menu prompt. The video
12
Diagnostic
Video Output Message
13
All Above Diagnostic
at the OBdiag Menu prompt. The all above
Output Message