Replacing The Speaker Assembly; Figure 6-9 Removing And Replacing The Speaker Assembly - Sun Microsystems Sun Blade 100 Service Manual

FIGURE 6-9
6.3.2

Replacing the Speaker Assembly

1. Position the speaker assembly into the chassis (
2. Grasp the speaker and press the speaker into the three chassis speaker slots.
3. Route the speaker cable and any other loose cables through the cable retaining
clip.
4. Connect the speaker cable to connector J12 on the riser board.
5. Replace the peripheral assembly:
a. Place the peripheral assembly back in position, aligning the three holes in the
peripheral assembly with the three securing screws on the chassis (see
FIGURE 7-1
b. Slide the peripheral assembly forward until it stops.
c. Using a No. 2 Phillips screwdriver, tighten the three securing screws.
d. Replace all of the cables into the cable retaining clip and secure the clip.
6. If you removed any long PCI cards, replace them.
See Section 8.4.2 "Replacing a PCI Card" on page 8-13.
J12 connector
Removing and Replacing the Speaker Assembly
on page 7-2).
Chapter 6
).
FIGURE 6-9
Removing and Replacing Major Subassemblies 6-15